Cody Forbes, Audi 5000 Turbo Quattro

Post Reply
Haudi
MegaSquirt Newbie
Posts: 13
Joined: Mon Aug 16, 2004 6:05 am
Location: Boca Raton, Fl
Contact:

Cody Forbes, Audi 5000 Turbo Quattro

Post by Haudi »

Name: Cody Forbes

Vehicle: Audi 5000 Turbo Quattro

Engine: Stock MC-1 2.2l 5cyl turbocharged

Injection: Multi-port using 5 42lb/hr Bosch low-z injectors

Description: My second MS'ed 5000TQ. Did the install because I hate
CIS, I wanted to run a bit more boost, and I hate CIS.

Website: 5000tq.com
Last edited by Haudi on Tue Oct 02, 2007 6:18 pm, edited 1 time in total.
Haudi
MegaSquirt Newbie
Posts: 13
Joined: Mon Aug 16, 2004 6:05 am
Location: Boca Raton, Fl
Contact:

Cody Forbes, Audi 5000 Turbo Quattro

Post by Haudi »

Update:

New website, 500tq.com.

Currenly running:
Ported Cyl head
Ported exaust manifold
KKK K26/K27 hybrid turbo
Blau 272 degree cam
Autotech 8000rpm valve springs
150hp three stage wet nitrous system
Haudi
MegaSquirt Newbie
Posts: 13
Joined: Mon Aug 16, 2004 6:05 am
Location: Boca Raton, Fl
Contact:

Cody Forbes, Audi 5000 Turbo Quattro

Post by Haudi »

385hp to the wheels as of last week!
Haudi
MegaSquirt Newbie
Posts: 13
Joined: Mon Aug 16, 2004 6:05 am
Location: Boca Raton, Fl
Contact:

Post by Haudi »

Just underwent a complete engine rebuild with ceramic coated pistons, an o-ringed block, and a few other tricks. New 17lb (vs 26lb stock) flywheel went on, and a KEP 6 puck un-sprung disc went in. Currently only 550miles on the engine, but I've done one or two on boost pulls and it's much stronger then before.

Image

Image

Image

Image
Haudi
MegaSquirt Newbie
Posts: 13
Joined: Mon Aug 16, 2004 6:05 am
Location: Boca Raton, Fl
Contact:

Re: Cody Forbes, Audi 5000 Turbo Quattro

Post by Haudi »

Another update.

I'm now running Coil-on-plug using BMW coils, Glens coil driver board, the MSExtra board, and completely standalone. Ignition input is 5+1 via 5 dowel pin installed in the flywheel read by the stock VR TDC sensor plus one dowel pin installed in the end of the camshaft where the distributor drive used to be and a Ford VR sensor.

Image

Also my MS is mounted inside the stock MAC-11 ECU case and using the stock wiring harness.

Image

With all of the updates I expect over 500whp and will have it on the dyno sometime this winter.
Post Reply