1995 GTI - 3.2L 24v VR6 on MS3

[Paul_VR6]

Once I get some of this VVT stuff figured out I'm going to build a tidy little 12v up on the cheap to turn heads. I think I can make more power.

Advance table isn't dyno tuned (at all) but is a pretty good representation of a reputable tuner's 'chip tune' advance table. Good place to start. Also this is on reg 93 octane pump. This motor does NOT like a whole lot of advance, especially when the intake is advanced. I need to take 4-5deg out from 20F to 100F intake temp in addition to using a little less initial over the 12v.

[DARKS[AINT]]

paul i would like to kno how much for a ms3 or a ms3 w/v3 to run a 9a 16v distributorless from the hall sender and also knock sensor....i notice icant get in touch u now but i need to know....its a 16v in a passat running CIS-E motronic with 2 knock sensors and an automatic....i wud very much like thins PnP so i will need the harness and anything u think i wud need plz help me

[Paul_VR6]

Sent you an email.

[powernut]

Once I get some of this VVT stuff figured out I'm going to build a tidy little 12v up on the cheap to turn heads. I think I can make more power


sounds arsome paul , keep me posted (mr powernut )think im going to call myself a vr recker