MS2-e 16vT Distributor Setup

Post Reply
valvecovergasket
MegaSquirt Newbie
Posts: 1
Joined: Sun Aug 28, 2005 1:02 pm
Location: raincity, wa

MS2-e 16vT Distributor Setup

Post by valvecovergasket »

Just wanted to toss this up here as a working distributor setup for MS2-e, didnt run across any in the searches and had a bit of a time sorting through the rising edge or falling edge triggering - thanks to Paul_VR6 for the help on that

Seems if you follow this (for 5v) from the MS2-e manual
Image
you need to use falling edge detection

and if you follow the jumper procedure outlined on DIY's site, you need to follow their setup guide for rising edge detection.

Attached my msq file - NOT tuned beyond idling and low speed maneuvering - for reference

Complete setup is a stock 16v distributor, MSD driving the coil, big injectors (hence the odd req_fuel #)
MS2-e 2.1.0d on a v3 board

enjoy
You do not have the required permissions to view the files attached to this post.
Post Reply