1988 AE82 4AGE smallport MS3

Toyota, Lexus.
Post Reply
drew
MegaSquirt Newbie
Posts: 3
Joined: Fri Jan 07, 2011 3:59 am

1988 AE82 4AGE smallport MS3

Post by drew »

1988 AE82 4AGE smallport

Running a modified cam pulley as a crank angle sensor machined to give a 36-1 setup at cam speed allowing for sequential spark and injection. All of the original sensors are picked up with a patch loom and extra wires run for the rest of the gear. Holden alloytec COP's are used for ignition along with standard injectors. Idle air controlled with GM stepper motor setup.

Image
Image
Image
Image
Image
CHB
MegaSquirt Newbie
Posts: 2
Joined: Sun Dec 04, 2005 11:52 pm
Contact:

Re: 1988 AE82 4AGE smallport MS3

Post by CHB »

You are very brave by removing a teeth from the cam pulley. Aren't you worry the timing belt will skip a teeth?
drew
MegaSquirt Newbie
Posts: 3
Joined: Fri Jan 07, 2011 3:59 am

Re: 1988 AE82 4AGE smallport MS3

Post by drew »

No i'm not worried about that. The cam belt is in contact with over a quarter of the timing gear at any one time. The number of teeth in contact with the belt even with one tooth removed is good. Been running around for a while now no probs.

Also being a non interference engine if the belt skips the worst thing that's going to happen will be power loss or the engine stopping.
DanielTorJJ
MegaSquirt Newbie
Posts: 1
Joined: Fri Dec 16, 2016 11:15 pm
Location: Haiti
Contact:

1988 AE82 4AGE smallport MS3

Post by DanielTorJJ »

That 4AGE 20V that use Ron 91/92 probably comes from the caribbean region...correct me if lm wrong
Post Reply