Page 1 of 1

'73 914 2.0L - On the road again

Posted: Mon Dec 26, 2005 5:55 pm
by CantConfirmOrDeny
Name: Paul Bennett
Vehicle: 1973 Porsche 914
Engine: 2.0L original stock everything.
Injection: MS-II / V3.0 / Fueling hardware is original factory port injection minus all the bits made redundant by MS-II. (ECU, Vac advance, MPS, throttle switch, etc.)
Description: Using MS-II to control fuel and spark with OE distributor, Bosch blue coil, Pertronix ignitor. Using original temp sensors, and tapped in to original fuel pump and +12V supply wiring. 1.3K pullup resistor on Pertronix gives usable signal to MS-II, and still drives the original tachometer.

Easy decision to go with MS-II when the original MPS failed. $1600 for a new one, if they can be found at all! Building this baby was a great learning experience, and car will be running better than new, I'm sure, once I get thru the tuning exercise. Runs well enough now to be my daily driver - will wring it out on the track during upcoming Porsche Club season.

Will post my .msq and .vex files in the near future…if I'd had these when I started, I could've done the whole job in about 4 weekends!

pix to come

Posted: Sat Dec 31, 2005 10:56 pm
by CantConfirmOrDeny
Pix to come, fer sure. Place is a mess right now - really has that Frankenstein's lab look. But it runs better than it has in years, and I've really only gotten started with the tuning...

VEX file for ignition timing

Posted: Sat Jan 28, 2006 10:22 pm
by CantConfirmOrDeny
This is a calculated VEX for the ignition timing. No actual tuning yet, but seems to run OK on the street.

msq & dump files

Posted: Sat Feb 04, 2006 1:09 pm
by CantConfirmOrDeny
Attaching a ZIP with current msq and dump files. Still a work in progress, but runs well enough to be my daily driver now.

Re: '73 914 2.0L - On the road again

Posted: Sun Oct 11, 2015 8:51 pm
by airfix4
Hello,
how did you use MSII to run stock ignition/dizzy?