Page 1 of 1

Anyone with MSII on 96 Range Rover 4.0 HSE

Posted: Sat Dec 18, 2010 11:31 pm
by streetrover
Hello,

Brand new here and need some help. Trying to start MSII system on a 1996 Range Rover 4.0 HSE engine. I'm using all the stock items (TPS, Trigger-wheel and sensor, injectors, etc.) but the MSII ECU. I get consistent spark from only one coil pack (2 cylinders) and occasionally a spark on one other coil. I'm not sure if I have a problem with my settings, crank sensor, or wiring. HELP!

Thanks,
Bob

Re: Anyone with MSII on 96 Range Rover 4.0 HSE

Posted: Thu Dec 23, 2010 5:44 pm
by Paul_VR6
I'm just starting to do research to put it on my 96 Disco.. but I've squirted tons of other vehicles. Do you know the crank wheel configuration? Does it use a missing tooth? Are you using the cam sensor? You try taking any trigger logs to see what the MS thinks its getting?

Re: Anyone with MSII on 96 Range Rover 4.0 HSE

Posted: Fri Feb 11, 2011 7:47 pm
by streetrover
Okay, here's the update:
Turns out I made a soldering mistake on the Megasquirt db15 connector. That mistake has been fixed. Fired up engine and IT RUNS! Next step...find a .msq file already dialed-in (or at least close) to my engine specs. Again, here's what I'm running...Megasquirt II ECU, firmware version 2.1.0, stock '96 4.0 litre HSE Range Rover engine. Can anyone help?