MS2-e 16vT Distributor Setup
-
- MegaSquirt Newbie
- Posts: 1
- Joined: Sun Aug 28, 2005 1:02 pm
- Location: raincity, wa
MS2-e 16vT Distributor Setup
Seems if you follow this (for 5v) from the MS2-e manual
you need to use falling edge detection
and if you follow the jumper procedure outlined on DIY's site, you need to follow their setup guide for rising edge detection.
Attached my msq file - NOT tuned beyond idling and low speed maneuvering - for reference
Complete setup is a stock 16v distributor, MSD driving the coil, big injectors (hence the odd req_fuel #)
MS2-e 2.1.0d on a v3 board
enjoy