Suzuki GSF400 Bandit
Re: Suzuki GSF400 Bandit
The TT600 TB's indeed lack injector ports. The fuel rail is attached to the TB assembly but on the Triumph they go into ports on the cylinder head. I'm not yet sure but I think I'll fab some additional runners after the TB's and place the injector ports in there. Maybe weld a vacuum tank on there too. The TT600 TB's outlet ports are a bit wider than the CB-1 Carb outlets so I need to do this anyways. A small taper from TB to cylinder head is always good. Speeds up the intake.
Re: Suzuki GSF400 Bandit
Re: Suzuki GSF400 Bandit
For quite a while I had the intention to go for an intank fuel as a replacement to the external inline pump I've been using so far. Main reason was the power consumption of the external fuel pump, simply too much for the B4 generator despite my attempt to reduce power consumption of the running bike by replacing every single lamp and bulb with LEDs (except for the headlight lamp). It did cut down a lot but still not enough. Also the whole fuel pump + pressure regulator + fuel hoses thing was taking up too much space and could not be easily accommodated at the bike's available free space. I have to confess that finding room to fit these parts had been the most difficult task of the project
![Rolling Eyes :roll:](./images/smilies/icon_rolleyes.gif)
However before I went on in spending extra cash for replacement fuel pump and fuel tank modification I wanted to make sure that the bike is running properly on its microsquirt brain. So I used the bike long enough and in almost any driving condition to make sure it does work and it does worth the money. And so it did, and in addition to that, during this "testing" period another deficiency of my simple fuel system appeared and made this kind of replacement more like a necessity rather than a "luxury" upgrade option. What I noticed was that the engine was stalling, when reservoir was low on fuel and especially when leaning for a left turn. I think that fuel flow to the pump (which was gravity fed from the tank) was simply not adequate under certain conditions and this would lead to engine fuel starvation.
So I started searching for a suitable fuel pump. After some research I concluded that the fuel pump from GSXR600 - 750 K8 and on would be the best possible fit. Low power consumption, integrated pressure regulator for a returnless fuel system (and at the same fuel pressure I was running before so no need to change anything in VE table), "sumpless" design for the pump housing cause there is no space available for anything extruding underneath the tank.
An attractive item popped up at ebay and went for it. A few days later I had the desired fuel pump in my hands.
![Image](http://i.imgur.com/QYzwrfJl.jpg)
Reservoir was sent off for the necessary modification. It was not an easy task. Due to its bottom shape and the free room available under the fuel tank the options were limited. It came out like this:
![Image](http://i.imgur.com/35kOKtql.jpg)
I would like to have it placed more close to the center of the tank but as I said, options were limited. I am quite pleased with the outcome!
![Image](http://i.imgur.com/oL5G7Kwl.jpg)
Too bad I had to remove the fuel level sender. It would be a nice little addition to the instruments cluster, but it wouldn't fit inside the tank...