Ford Kent X-flow MS2 PCB3.0 files?
Posted: Sun Apr 14, 2013 3:41 pm
Im in the process of installing yamaha r6 throttle bodies on my x flow using a megasquirt 2 and edis4. Iv just finished the ecu and it is up and running. I dont have the stimulator so have only been able to test MAP and throttle position. Im just doing bench testing at the moment and it will go in the car shortly.
Its got Monitor_v2.920.abs.s19 firmware and tunerstudio 2.08 with megasquirt-II_2920.ini
I want to use ms2_extra.s19 and megasquirt-ii.ms2extra.ini. The firmware flashes fine but it wont connect in tunerstudio gives a serial error. This I assume I should ask on the msextra.com forum.
What im looking for at the moment is a base table for ignition and fuel. Does anyone have anything that would make for a good starter?
Cheers
Its got Monitor_v2.920.abs.s19 firmware and tunerstudio 2.08 with megasquirt-II_2920.ini
I want to use ms2_extra.s19 and megasquirt-ii.ms2extra.ini. The firmware flashes fine but it wont connect in tunerstudio gives a serial error. This I assume I should ask on the msextra.com forum.
What im looking for at the moment is a base table for ignition and fuel. Does anyone have anything that would make for a good starter?
Cheers