www.MSruns.com read only forum (Jan.15,2018)

Thought maybe the folks on the board might be interested in seeing photos of the setup that I built for my 452 cu. in. BigBlockDart Convertible. All the work on this system has been done by myself using only basic hand and air tools and drill press and a Miller welder spoolgun.
I got the system running last night 4/20/2005. Not well yet, but running. Can't get 4 wire O2 sensor to work/read out in megatune. Does not want to idle very well. BUT IT DID START on the FIRST TRY. I'll keep reading and tuning. I will get it figured out sooner or later.







Herb

Mods, if this is in the wrong place, please move it to the correct location

That is one sanitary engine bay! Stunning! I really like the detailing you have accomplished. Those fuel rail hold downs with the chrysler emblem is top notch!

Great Job, I am certain you will be running soon!
Good Luck!
Bruce

what manifold did you use for this setup? it looks like an edelbrock torker.