www.MSruns.com read only forum (Jan.15,2018)

Great job!Its good to see guys who can build stuff like this all on their own.

http://www.youtube.com/watch?v=AcDVKLL3RIM here is a video of my car after very little tuning.

not fast enough!

Yeah,I know what you mean.Its -7 below here in Wisconsin and I am gettin antsy to get the cars out.When I do though,I will get you the maps I used.Iknow what yo mean about hood clearance,my intake pipes rubbed on the hood so I put a couple large washers under frame bushings and took care of it.You h...

Just an update on my car.Still occasionally runs very rich until you shut it off for a few seconds and restart it then it is fine??? Going to schedule a dyno session in spring when weather warms up and I replace my clutch :( as the ram hd powergrip is not near enough clutch for this combo.I will try...

Started tuning tonite.Created my own VE table from scratch.Brought my wife along first to write down numbers for me as I went thru the gears,made my adjustments and went back out with my 14 year old.Had to make an extra run with him cause he was pinned against the seat and dropped the pen :D {I know...

Well she cranked over a couple times and fired right up tonite. Idles at 1050 rpm 12.5 afr.Everything seems rock steady.Now I am ready to start tuning.Stay "tuned".

So here is my project thus far.555 bbc merlin block and fully ported heads hyd roller cam.Tremec tko600 5 speed and 4.10 gears.I broke in the motor with an hp1000 holley and set timing.I have owned the car since I was 15[23 years] and it has seen 24 different engine combinations.This is the third in...