Tim's 1992 GTI VR6
Tim's 1992 GTI VR6
Board built and tuned by me.
MS1 V3
MSnS-E 029t
Board mods/hardware:
VRIN - TSEL
TSEL - VROUT INV
D14 with pullup to IGN (no VB)
Both VR pots fully CCW
Launch Circuit
Tach Circuit (not working yet)
TIP120 for PWM idle valve with 1N4001 flyback diode
Innovate LC1 wideband
MS adapter harness using an old Motronic ECU connector to maintain ability to go back to stock ECU for ... whatever. Engine bay looks STOCK.
Street tuned msq below
1995 GTI VR6 12.833@105
2.8l 12v on MS1-3.57/HR10G - retired
3.2l 24v on MS3 - beta test completed - retired
??? on MS3/3x/IOx/? next up...K&P Performance - KPTuned.com
Thanks for posting your tune file, should be helpful!
I did have a 2mm overbore 2.9L motor in that same car when I had it. Though that block lives in a 500+ whp turbo car now.
The next motor for my car will probably be a stock block engine decked a LOT for high compression.
Hope the file helps!
1995 GTI VR6 12.833@105
2.8l 12v on MS1-3.57/HR10G - retired
3.2l 24v on MS3 - beta test completed - retired
??? on MS3/3x/IOx/? next up...K&P Performance - KPTuned.com