62 Ford Falcon with 331 Stroker - MS2 V3 EDIS8
-
- MegaSquirt Newbie
- Posts: 11
- Joined: Sun Feb 15, 2009 4:39 pm
62 Ford Falcon with 331 Stroker - MS2 V3 EDIS8
My engine is a 331 stroker based on a later 5.0 block. It has Edelbrock EFI manifold, throttle body, fuel rails, and pico 29lb injectors. I finally finished wiring all the sensors and IAC. I have the injector harness well under way. I'm just waiting for some refill parts for my Weatherpack kit.
I have a LC1 wideband sensor mounted just after the X-pipe in my dual ehaust syste, I was able to verify it's function prior to pulling the old carb and manifold.
I'll be starting out with fuel only and then will switch to EDIS8.
-
- MegaSquirt Newbie
- Posts: 11
- Joined: Sun Feb 15, 2009 4:39 pm
Re: 62 Ford Falcon with 331 Stroker - MS2 V3 EDIS8
-
- MegaSquirt Newbie
- Posts: 11
- Joined: Sun Feb 15, 2009 4:39 pm
Re: 62 Ford Falcon with 331 Stroker - MS2 V3 EDIS8
There is still plenty of tuning to do.
This is a fuel only setup. I wanted to get it running that way before tackling the EDIS8 stuff.
Some remaining tasks:
1) Wire fuel pump properly so it isn't on all the time.
2) Wire the electric fan control into the MS2.
3) Install EDIS8 ignition.
4) TUNE-TUNE-TUNE
-
- MegaSquirt Newbie
- Posts: 11
- Joined: Sun Feb 15, 2009 4:39 pm
Re: 62 Ford Falcon with 331 Stroker - MS2 V3 EDIS8
I'v been tuning the startup, warmup, and idle settings. It starts from cold on the first try now and runs good. The accel enrichment needs a little work. I'll try some short drives out on the street with autotune this weekend.
-
- MegaSquirt Newbie
- Posts: 3
- Joined: Fri Jan 01, 2010 10:07 pm
Re: 62 Ford Falcon with 331 Stroker - MS2 V3 EDIS8
car looks good
-
- MegaSquirt Newbie
- Posts: 11
- Joined: Sun Feb 15, 2009 4:39 pm
Re: 62 Ford Falcon with 331 Stroker - MS2 V3 EDIS8
I turbo would be fun. Hmmm. Maybe I should build a twin turbo based on a Dart block.
-
- MegaSquirt Newbie
- Posts: 11
- Joined: Sun Feb 15, 2009 4:39 pm
Re: 62 Ford Falcon with 331 Stroker - MS2 V3 EDIS8
-
- MegaSquirt Newbie
- Posts: 3
- Joined: Fri Jan 01, 2010 10:07 pm
Re: 62 Ford Falcon with 331 Stroker - MS2 V3 EDIS8
-
- MegaSquirt Newbie
- Posts: 11
- Joined: Sun Feb 15, 2009 4:39 pm
Re: 62 Ford Falcon with 331 Stroker - MS2 V3 EDIS8
-
- MegaSquirt Newbie
- Posts: 11
- Joined: Sun Feb 15, 2009 4:39 pm