86 Daytona, 2.2L CB, turbo IC, 555 trans
Posted: Wed Jul 04, 2007 10:49 am
The ease of this venture is attributed to my son. I built the car and the custom wire harness, but he does all the computer work.
Using my sons MS, because his cars down for repair due to a little bit to much nitros, the car fire right up (after a few minutes cranking it with out the rotor - my bad) and ran good. for now we are using the stock distributor, HEP and coil. soon we will be going to wasted spark.
We (my son) will by tuning it over the next few weeks. My plans are to run 20+ psi boost and incorporate a rev limiter to help launch the car.
Using my sons MS, because his cars down for repair due to a little bit to much nitros, the car fire right up (after a few minutes cranking it with out the rotor - my bad) and ran good. for now we are using the stock distributor, HEP and coil. soon we will be going to wasted spark.
We (my son) will by tuning it over the next few weeks. My plans are to run 20+ psi boost and incorporate a rev limiter to help launch the car.